How to Use

Incident Light Sensor/External GPS How To Use Instructions

Before Starting

Reflectance Panel

If a reflectance panel is also being used see the page linked below:

pageHow To Use

---

Install Light Sensor/GPS

1. Install the light sensor and gimbal onto the aircraft.

2. Connect the USB-C cable to the light sensor.

3. Secure the cable to the aircraft.

4. Connect the USB-C cable to the port on the gimbal.

For Gimballed Sensors

Connect the light sensor/GPS to the USB-C port on the gimbal

For Non-Gimballed Sensors

Connect the light sensor/GPS to the USB-C port on the 6X

Power on Aircraft & Verify Status LEDs

1. Power on the aircraft. This will also power the gimbal, sensor, and light sensor on.

2. Verify the Status LEDs shown below have all turned solid green.

Fly

The sensor and light sensor are now ready for flight.