Standard Operating Procedure
6X Multispectral Sensor Standard Operating Procedure Introduction
Operational Modes
The 6X can operate in two different modes. Each of these modes has a slightly different Standard Operating Procedure (SOP).
Integrated Mode (Most Common)
In this mode the 6X ingests triggering commands and GPS/Altitude/Attitude from the drone to capture and geotag imagery.
Default Configuration
| Aircraft | Config Name |
|---|---|
DJI M300/350 | DJI Skyport |
DJI M200/210 | DJI Skyport |
Freefly Astro | Freefly Astro Gimbal |
Inspired Flight IF1200A | Inspired Flight IF1200A |
Inspired Flight IF800 | Inspired Flight IF800 |
Standard Operating Procedure - Integrated Mode
pageIntegrated Mode (Most Common)Stand Alone Mode (Sentera GPS)
In this mode the 6X uses GPS data from the light sensor/GPS module to determine when it should trigger the camera.
Default Configuration
| Aircraft | Config Name |
|---|---|
DJI Inspire 1 | Sentera GPS |
DJI Inspire 2 | Sentera GPS |
DJI M100 | Sentera GPS |
OEM 6X Sensor | Sentera GPS |
Aircraft must be flown in an East facing direction.
OEM 6X Sensors flown in this configuration will have Pitch & Roll locked at 0 degrees.
Standard Operating Procedure - Stand Alone Mode (Sentera GPS)
pageStand Alone Mode (Sentera GPS)Notes
Operational mode and capture settings are selected using the configuration menu.
Advanced or custom configurations of the 6X may required a modified standard operating procedure.
Last updated
