Offload Process

Getting Started

The 65R stores the imagery on an internal solid state hard drive that is not removable from the sensor. Use the process outline below to access the collected data.

Imagery is NOT stored on the micro SD card.

Power On Sensor

Power the 65R using the AC adapter or keep it attached to the aircraft and turn the aircraft on.

Connect USB Cable to Sensor and Computer

Open a File Browser Window

Navigate to Sensor Storage

Navigate to the 65R internal storage by typing \\192.168.42.1 into the address bar of the file browser and pressing enter.

The sensor may need a minute to fully boot before it can be accessed via the file browser.

If the 65R can't be connected to after a few minutes try the following: - Turn off/disconnect any Wi-Fi or Ethernet connections that have internet access. - Verify the USB cable being used is the provided cable or one of the listed compatible cables.

Adding this file path to Quick Access can be helpful for repeated use.

Windows will display a network credentials pop-up. The user name is sentera and there is no password. Press OK.

If your user account is controlled by a domain .\sentera may need to be used as the username.

Select Data Folder

Select Snapshots Folder

Select Session Folder

Session folders are the folders where the imagery is stored for each flight.

If the 65R is not power cycled between flights that are intended to be separate (i.e. not a battery swap) all of the photos from both flights will be stored in the same session folder.