Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Incident Light Sensor Installation - DJI M300/350
Clean mounting bracket with alcohol wipe and let dry.
Place mounting bracket onto the aircraft. The longer legs of the mounting bracket should be pointed towards the front of the aircraft.
Use the provided screws to attach the bracket to the aircraft.
Remove the adhesive backing from the mounting tray and place onto the mounting bracket as shown. Press firmly into place.
Use the alcohol wipe to clean the side of the aircraft and let dry.
Remove the adhesive back of the cable clip and attach to the side of the aircraft as shown. Press firmly into place.
Install the equipment in the shown orientation. This allows the light sensor, cable, and gimbal to be connected safely and effectively.
Incident Light Sensor Installation - DJI M200/210
Clean the top of the aircraft with an alcohol wipe and let dry.
Remove the adhesive backing from the mounting tray and place onto the mounting bracket as shown. Press firmly into place.
Use the alcohol wipe to clean the side of the aircraft and let dry.
Remove the adhesive back of the cable clip and attach to the side of the aircraft as shown. Press firmly into place.
Place the mounting tray in the shown location. Placing the mounting tray further towards the nose of the aircraft may block the internal aircraft GPS.
Install the equipment in the shown orientation. This allows the light sensor, cable, and gimbal to be connected safely and effectively.
Incident Light Sensor Installation - DJI Inspire 1 & 2
Remove the 2 screws shown using a 2.5mm hex driver.
Place mounting bracket onto the aircraft as shown.
Reinstall the screws.
Clean the top of the mounting bracket with an alcohol wipe and let dry.
Remove the adhesive backing from the mounting tray and place onto the mounting bracket as shown. Press firmly into place.
Use the alcohol wipe to clean the side of the aircraft and let dry.
Remove the adhesive back of the cable clip and attach to the side of the aircraft as shown. Press firmly into place.
Install the equipment in the shown orientation. This allows the light sensor, cable, and gimbal to be connected safely and effectively.
Incident Light Sensor Installation - Freefly Astro
Attach the mounting tray to the mast using the attached adhesive tape.
Use the provided M3 x 8mm screws and 2.5mm hex driver (provided with Astro) to attach the mast to the aircraft.
When installed correctly the Light Sensor/GPS mount should allow the Astro to fit in the case while still attached. However, the light sensor itself will need to be removed from the mounting tray.